Take a deep breath in…now slowly breathe out. Mmm isn’t it wonderful? All that air around us, which we bring into our lungs, extracts oxygen from and then breathes out carbon dioxide. CO2 is essential for life on this planet we call Earth – we and plantstake turns using and emitting CO2 in an elegant symbiosis. But it’s important to keep that CO2 balanced – you don’t want too much around, not good for humans and not good for our planet.The SCD-41is a photoacoustic ‘true’ CO2 sensor that will tell you the CO2 PPM (parts-per-million) composition of ambient air.Unlike the SGP30, this sensor isn’t approximating it from VOC gas concentration-it really is measuring the CO2 concentration! That means it’s bigger and more expensive, but it is the real thing. Perfect for environmental sensing, scientific experiments, air quality and ventilation studies, and more.Compared to the illustrious SCD-30, this sensor uses a different measurement technique, which allows it to be much smaller. The overall data quality should be very similar, however. Like the SCD-30, this sensor has data read over I2C, so it works very nicely with just about any microcontroller or microcomputer. There’s both Arduino and Python/CircuitPython code so you can get started in a jiffy.There are two variants of this sensor – the SCD-40 and SCD-41TheSCD-40is lower cost and is perfect for indoor/outdoor air quality and CO2 measurements. It has a range of400~2000 ppmwith an accuracy of (50 ppm + 5% of reading)TheSCD-41is more expensive, and while it can definitely be used for air quality, it’s wide range means it’s best used for industrial or scientific CO2 measurements where the ppm can get very high. It has a range of400~5000 ppmwith an accuracy of (40 ppm + 5% of reading)Nice sensor, right? So we made it easy for you to get right into your next project. The sensor is soldered onto a custom-made PCB in theSTEMMA QTform factor, making them easy to interface with. TheSTEMMA QT connectorson either side are compatible with theSparkFun QwiicI2C connectors. This allows you to make solderless connections between your development board and the SCD-4x or to chain it with a wide range of other sensors and accessories using acompatible cable.This sensor can run from 3.3 to 5V but it’s more important for it to have a quiet power supply with low ripple, than any particular voltage. For that reason, we’ve added a 3.3V regulator and level shifters: when connecting to a 5V microcontroller like an Arduino UNO the 5V supply is often shared with other electronic components that add noise. The onboard regulator will keep the voltage nice and quiet. For advanced hackers, they can cut/solder the backtraces to change whether the regulator is enabled and what I2C logic level is desired.Technical DetailsPhotoacoustic CO2 sensor technologyIntegrated temperature and humidity sensorMeasurement range: 400 ppm 5000 ppmAccuracy:(40 ppm + 5 % of reading)Current consumption: 17 mA (meas. rate = 5 s) / 0.5 mA (meas. rate = 5 min)Fully calibrated and linearizedI2C digital interface address 0x61Sensor Element Size: 10.1mm x 10.1mm x 6.5 mmProduct Dimensions: 25.5mm x 22.8mm x 7.7mm / 1.0″ x 0.9″ x 0.3″Product Weight: 2.8g / 0.1oz